MTB Riyadh

How to choose MTB tyres for Riyadh: speed, grip and puncture protection

Go tubeless, run lower pressure than you think, and match the tread to your terrain. Small knobs for hard desert tracks, reinforced sidewalls and sealant for rocks and thorns, wider tyres for loose sand. Speed matters less than not getting a flat.

## Find your tyres in 3 questions

## The short version of the science

A tyre does four jobs at once: it **rolls fast**, it **grips**, it **resists punctures** and it **absorbs bumps**. You cannot max all four. Every tyre is a trade-off, so the right question is not "which tyre is best?" but "which trade-off suits my trails?"

## 1. Speed: what really slows a tyre down

Rolling resistance is the energy a tyre wastes every metre. Three things cause most of it:

- **Casing flex.** A thinner, more supple casing wastes less energy as it flexes. Thick, reinforced casings are slower.

- **Rubber compound.** Softer rubber grips better but usually rolls slower and wears faster.

- **Tread knobs.** Big, tall knobs squirm and drag on hard ground. Small, closely spaced knobs roll faster.

> **A surprise that helps you:** on smooth tarmac, more pressure is faster. On rough trails it is the opposite. A tyre that is too hard bounces off every bump, which shakes you and the bike and wastes energy. A softer tyre moulds around the bump and keeps rolling. Slightly lower pressure is often both faster and more comfortable off-road.

## 2. Puncture resistance: what stops thorns and sharp rock

- **Go tubeless.** There is no inner tube to pinch, so you can run lower pressure without pinch flats. Liquid **sealant** closes small holes (thorns) while you ride.

- **Reinforced sidewalls** protect against cuts from sharp rock on the side of the tyre. They add weight and a little rolling resistance. For rocky wadis and escarpments this is usually worth it.

- **Sealant: how much and how often.** The amount depends on your tyre size (about 100 to 140 ml for a 29-inch tyre), and heat dries it sooner, so look inside the tyre rather than trusting a date. The makers' figures are in the sealant guide below.

## 3. Choosing by terrain

| Where you ride | Tread | Width | What to remember |

| --- | --- | --- | --- |

| Hard-packed desert track, fast loops | Small, low knobs | 2.2 to 2.35 in | Fastest. Keep a reinforced casing if there are thorns. |

| Rocky wadi, escarpment | Medium knobs, reinforced sidewall | 2.3 to 2.4 in | Grip and cut protection matter more than speed. |

| Loose sand or deep gravel | Taller, widely spaced knobs, wider tyre | 2.4 in or wider | Wider and softer floats better. Lower pressure helps a lot. |

| Mixed: road to trail | Fast centre, grippy edge knobs | 2.2 to 2.3 in | A good all-round choice for most Riyadh rides. |

## 4. Pressure: start here, then adjust

Pressure is the cheapest speed and grip upgrade you own. These are **starting points** for tubeless 2.2 to 2.4 in tyres on trails. Your weight, rim width and tyre all change the best number:

- Lighter rider (under about 65 kg): around 17 to 21 psi (1.2 to 1.45 bar).

- Average rider (about 65 to 85 kg): around 19 to 24 psi (1.3 to 1.65 bar).

- Heavier rider (over about 85 kg): around 22 to 27 psi (1.5 to 1.85 bar).

Then adjust by 1 to 2 psi at a time:

1. Rim hits, burping air or a squirmy, vague feel in corners: **add pressure**.

2. Bouncing, chattering or poor grip on rocks: **remove pressure**.

3. Change one thing at a time, ride the same loop, and compare how it feels.

> **Heat changes pressure.** Air expands when it is hot. A tyre set to 20 psi at 25 °C reads about 21 psi at 45 °C. Set your pressure when the tyres are at the temperature you will ride at, not in a cool garage.

## Quick checklist

1. Tubeless with fresh sealant.

2. Reinforced sidewall if you ride rocks or thorns.

3. Tread matched to your usual terrain.

4. Pressure at the lower end of your range, adjusted by feel.

5. Check pressure and sealant before every big ride.

Sources

  • Independent tyre rolling-resistance test data (bicyclerollingresistance.com)
  • Tyre pressure and rolling-resistance research, Silca (silca.cc) - impedance on rough surfaces
  • Gas law: pressure rises with absolute temperature (P/T constant), used for the heat example