Tubeless sealant: how much, how to add it, and when to check it (Riyadh heat and rocks)
The amount depends on tyre size: about 100 to 140 ml per 29-inch MTB tyre. Heat and rocks do not change the amount, but they use the sealant up sooner, so look inside the tyre instead of trusting a date. The makers publish no Riyadh-specific figures, and this guide says where it is giving convention, not research.
## The short answer
- **How much** depends on your **tyre size**, not on the season. For a 29-inch mountain bike tyre the makers publish about **100 to 140 ml (3.4 to 4.7 oz) per tyre**.
- **Riyadh heat** does not change the amount. It changes **how fast the sealant dries**, so you check and top up **sooner** than the maker's average.
- **Rocky ground** also has no published extra amount. It uses sealant faster, because more punctures get sealed. Check sooner, and consider a sealant made for bigger holes.
*Evidence level: Manufacturer specification (Stan's, Muc-Off), plus clearly marked convention where nothing is published.*
## 1. How much sealant: the makers' tables
Both brands say the amount is set by tyre size. These are their published starting amounts for a **29-inch** mountain bike tyre.
| Tyre | Stan's Original and Race Day | Muc-Off MTB sealant |
| --- | --- | --- |
| 29 x 2.2 | 100 ml (3.4 oz) | 105 to 140 ml for any 29-inch MTB tyre |
| 29 x 2.3 | 105 ml (3.5 oz) | same |
| 29 x 2.4 | 110 ml (3.7 oz) | same |
| 29 x 2.5 | 125 ml (4.2 oz) | same |
| 29 x 2.8 | 130 ml (4.4 oz) | same |
| 29 x 3.0 | 140 ml (4.7 oz) | same |
| Downhill (Muc-Off) | n/a | 120 to 140 ml |
- Stan's says: *"Because tire casings vary widely between manufacturers, some tires may require more tubeless sealant."* A porous tyre can need more, and may need a refresh soon after the first set-up.
- Stan's publishes a second, older table on another page with rounder numbers (for example 118 ml for 29 x 2.3). The two pages disagree, so use the main chart above.
- Muc-Off prints fill lines on its pouch for each tyre size. Follow those.
## 2. Riyadh: winter and summer
**What the makers say**
- Stan's: the sealant lasts **an average of 2 to 6 months**, depending on *"temperatures and humidity in your area, how often you ride, where you store your bike (cooler is better), tire casing thickness, number of punctures the sealant has already sealed"*. Another Stan's page says it stays liquid **2 to 7 months** depending on your local climate. Stan's suggests checking or refreshing about **every three months**.
- Muc-Off: it can dry out **up to 6 months in temperate climates**, and it recommends checking and topping up **every 6 months** and swapping old sealant for new **every 4 to 6 months**. It works from **-20 C to +50 C**.
- Stan's Race Day sealant: inspect **every two to three weeks**.
**What is not published**
- No maker gives a different amount, or a Riyadh-specific interval, for summer or winter. We did not find one.
- So the calendar numbers above are for average climates. Our heat sits at the **short end** of those ranges. How short is not measured.
**What to do (convention: no research behind it)**
1. Do not rely on a date. **Look inside the tyre.** With a removable valve core, remove it with the wheel turned so the valve is at the bottom, and shine a light in. You should see liquid, not dry flakes or nothing.
2. In the hottest months check more often than in winter. Check before a race or a long ride.
3. To top up, add one **60 ml (2 oz)** bottle. That is Stan's own top-up amount for its standard sealant.
4. Store the bottle **tightly closed in a cool, dry place** (Stan's). Do not leave it in a hot car.
## 3. Rocky terrain
**What the makers say**
- Stan's Original seals punctures **up to 6.5 mm (a quarter inch)**.
- Stan's Race Day sealant has **twice the particles plus extra-large crystals** to seal bigger punctures. It needs inspecting more often, it cannot go through the valve (you must unseat the bead and pour it in), and it can be mixed with the standard sealant.
- One of the things Stan's lists as shortening sealant life is the **number of punctures it has already sealed**.
**What is not published**
- No maker gives an extra volume for rocky ground.
**What to do (convention: no research behind it)**
- Inside the maker's range for your tyre, start at the **upper end**.
- Check sooner after rides with a lot of thorns or sharp rock.
- Sealant is not a cure for every cut. Depending on the puncture, Stan's says you may need to add air or sealant as soon as it happens. Carry a pump and a spare tube.
## 4. How to add sealant
**Through the valve (no need to remove the tyre)**
1. Release the air. Remove the valve core with a core tool.
2. Shake the bottle well. Squeeze or inject the amount in.
3. Put the valve core back in.
4. Spin the wheel so the sealant spreads around the tyre.
5. Pump up to your pressure.
**Pouring it in (needed for Race Day sealant, or for a full refresh)**
1. Release the air and unseat one side of the tyre from the rim.
2. Pour the sealant in.
3. Push the tyre back onto the rim, then spin the wheel and pump up.
Sealing crystals settle, so **shake the bottle well** every time (Stan's). Liquid sealant may affect the warranty with some tyre makers, so check yours.
## Method and references
- This guide only repeats what the sealant makers publish. **MTB Riyadh did not develop these numbers**, and the club has not tested them in Riyadh heat.
- Stan's NoTubes: How much sealant should I add to my tires? (stans.com/pages/how-much-sealant); Sealant support FAQ (stans.com/pages/sealant-support); Tubeless guide (stans.com/pages/tubeless-guide). Checked 30 Oct 2026.
- Muc-Off: How and when to add tubeless sealant (muc-off.com/blogs/how-to-hub/how-to-use-muc-off-no-puncture-hassle-tubeless-sealant); No Puncture Hassle FAQ; 5 steps to revamping your tubeless sealant. Checked 30 Oct 2026.
- **Not verified:** any amount or interval specific to Riyadh, to summer or winter, or to rocky ground. Stan's own pages give 2 to 6 and 2 to 7 months. A statement found on a retailer page about checking sealant "every couple of months above 35 C" was not on Muc-Off's own pages, so it is not used.
Sources
- Stan's NoTubes: How much sealant should I add to my tires?
- Stan's NoTubes: Sealant support (lifespan, storage, Race sealant)
- Stan's NoTubes: Tubeless guide (puncture size, refill interval)
- Muc-Off: How and when to add tubeless sealant
- Muc-Off: 5 steps to revamping your tubeless sealant